Circular Saw Tips and Techniques

Circular saw tips and techniques when ripping plywood, or cutting tiles you'll do the carpentry job better if you follow a few basic guidelines for using a circular saw whenever you cut, allow the saw to reach full operating speed, then slowly push the blade into the wood. Some carpenters look at the blade as they cut; others rely on the gun sight notch. Choose the method that suits you best. Avoid making slight turns as you cut. Find the right path, and push the saw through the material smoothly It will take some practice before you can do this consistently. This is a powerful tool with sharp teeth, so take care. It demands your respect. Support the material to avoid having the saw bind and possibly kick back at you. Don't wear loose-fitting long sleeves or position your face near the blade. This page just touches the surface of Circular Saw Tips there will be more to come so stay tuned

 

CIRCULAR SAW AND BLADES 

Choose a circular saw that is comfortable. It should have some heft, but should not be so heavy that it is difficult to maneuver. You should be able to see the blade and gunsight notch easily. Check for ease of depth and angle adjustments. le If you buy only one blade for cutting lumber and plywood, chose a carbide-tipped combination blade that has at least 24 teeth. It works well for rough work and makes cuts clean enough for most finish work. For more specialized uses, buy a plywood blade, a finishing blade, or a masonry blade.

 

Support the material properly

A well-supported board results in clean, safe cuts. If the scrap piece is short, support the board on the nonscrap side. If the scrap is long, it could bind the blade or splinter as it falls away at the end of the cut. so support it in four places.

 

Align the blade with the cut line.

Once you have drawn an accurate cutoff line and have properly supported the board, position the saw blade on the scrap side of the line. The teeth on most blades are offset in an alternating pattern. When preparing to cut, look at a tooth that points toward the cutoff line.

 

Square the blade. 

Turn the saw upside down, hold a square against the blade, and adjust it. (Be sure to position the square between the teeth.) Cut some scrap pieces and check to make sure the saw cuts squarely through the thickness of the board. Continue to visit for more info on basic carpentry. Thanks for visiting this page on Circular Saw Tips